
Vato Tuned Honda OBD1 Engine Simulator
From 9,979.00TL

P/N VTHPNP
For off-road and race use only.
A fully programmable replacement for the factory Honda OBD1 ECU. It plugs straight into the stock engine harness, so there is no rewiring and nothing to cut. The original A/C system and dash keep working.
Tune it in TunerStudio over USB-C, or wirelessly with the Wi-Fi option. The TunerStudio INI file is stored on the ECU, so TunerStudio finds it when you plug in. Logs record to the onboard micro SD card.
It fits the stock USDM OBD1 Civic and Integra ECU case. Firmware updates use FOME console, which comes in the firmware bundle.
| Outputs | |
|---|---|
| Coil-on-plug drivers | 4 |
| Low side outputs, low current | 7 |
| Low side outputs, high current | 7 |
| High side outputs, high current | 2 |
| Full-bridge output (electronic throttle) | 1 |
| Inputs | |
| Digital inputs | 6 |
| Trigger inputs (VR or Hall) | 2 |
| Analog inputs, 0–5 V | 15 |
| Knock input | 1 |
| Onboard | |
| Barometric pressure sensor | Yes |
| Wideband controller (LSU 4.9) | Optional |
| Data logging | Micro SD card |
| USB | USB-C |
| CAN bus | Yes, OBD2 and aftermarket gauges |
| Wi-Fi | Optional, internal or external antenna |
| Status lights | 4: Warning, Running, Com, Error |
| Tuning | |
| Closed-loop fuel | Yes |
| Launch control | Yes |
| Boost control | Yes |
| Flex fuel | Yes |
| Knock control | Yes |
| Electronic throttle | Yes, with the drive-by-wire option |
| Physical | |
| Connector | Honda OBD1 A / B / D (26 / 16 / 22 pin) |
| Firmware | FOME |
| Power supply | 6 to 18 V, 5 A rating |
| Operating temperature | −40 to 85 °C |
| Dimensions | Fits the stock USDM OBD1 Civic / Integra ECU case |
| Weight | 120 g |
| Ordering | |
| Kit contents | ECU, USB cable, 2-pin CAN bus cable, 5 small pins for the ECU header |
| Warranty | 2 years |

From 9,979.00TL

From 3,583.00TL

From 7,677.00TL